WIRELESS MIСROPHON SHURE BETA 98H/BLX4R (TRUMPET)

Share with friend

Kristiine, Tallinn, Harju maakond, Estonia

6 970km away
Rent WIRELESS MIСROPHON SHURE BETA 98H/BLX4R (TRUMPET) photo 1
Rent WIRELESS MIСROPHON SHURE BETA 98H/BLX4R (TRUMPET) photo 2
Rent WIRELESS MIСROPHON SHURE BETA 98H/BLX4R (TRUMPET) photo 3
Rent WIRELESS MIСROPHON SHURE BETA 98H/BLX4R (TRUMPET) photo 4
Rent WIRELESS MIСROPHON SHURE BETA 98H/BLX4R (TRUMPET) thumbnail 1 Rent WIRELESS MIСROPHON SHURE BETA 98H/BLX4R (TRUMPET) thumbnail 2 Rent WIRELESS MIСROPHON SHURE BETA 98H/BLX4R (TRUMPET) thumbnail 3 Rent WIRELESS MIСROPHON SHURE BETA 98H/BLX4R (TRUMPET) thumbnail 4
The Beta 98H/C™ is a premium cardioid condenser instrument microphone that clamps onto the bell of wind instruments or onto the rim of percussion instruments.
The integrated gooseneck and ratcheting swivel joint allows the mic to be easily positioned and secured, and an isolation shock-mount reduces the transmission of instrument 'key noise' and other mechanical noise. A gooseneck angle brace is included to provide better retention of the microphone placement during more active performances.
Applications and Placement
The most common BETA 98H/C applications and placement techniques are described below. Keep in mind that microphone technique is largely a matter of personal taste; there is no one "correct" microphone position.
Saxophone Placement: Clamp the microphone onto the bell of the saxophone, so the microphone is a few inches from and facing into the bell. This will produce a bright tonal balance while minimizing feedback and leakage.
Soprano Saxophone Placement: Clamp the microphone onto the bell of the saxophone and adjust the gooseneck so the microphone is facing the keys of the instrument, a few inches from the lower keys. This will produce a warm and full tonal balance. For a brighter tone, adjust the gooseneck so the microphone is facing into the bell, a few inches away.
Trombone Placement: Clamp the microphone onto the bell of the trombone and adjust the gooseneck so the microphone is facing directly into the bell, a few inches away. This will produce a bright tonal balance while providing maximum isolation.
Trumpet Placement: Clamp the microphone onto the bell of the trumpet and adjust the gooseneck so the microphone is facing directly into the bell, a few inches away. This will produce a bright tonal balance while providing maximum isolation.
Drum Placement: Clamp the microphone onto the drum rim and adjust the gooseneck so the microphone is aiming a few inches above the drum head and an inch from the rim. This provides a full tonal balance.
Specifications:
Type: Condenser (electret bias)
Polar Pattern: Unidirectional (cardioid)
Frequency Response: 20 to 20,000 Hz
Output Impedance: 1200 ohms
Output Level (0 dB = 1 volt per Pascal): Open Circuit Voltage: -56.5 dB (1.5 mV)
Output Clipping Level (at 1kHz, THD < 1%): -9 dBV (0.35 V)
Maximum SPL: 143.5 dB
Dynamic Range: 112.5 dB
Signal-to-noise Ratio: 63 dB at 94 dB SPL (IEC 651)
Polarity: Positive pressure on microphone diaphragm produces positive voltage on pins 3 and 4 with respect to pin 1 (ground).
Weight of the microphone: 65 g
Weight of the preamplifier: 96 g
~ Acceptance rate
~ 12 hours 9 minutes Average response time

Minimum rent period 1 day
Maximum rent period 1 month

Location 6 970km away
35€ /day
96€
3 days
163€
week
525€
month
Unfortunately, this listing has been disabled and is unavailable for rent!
Explore other other electronics nearby.
~ Acceptance rate
~ 12 hours 9 minutes Average response time
35 € per day

Similar results for rent Other electronics in Tallinn

Tallinn
Deposit 100 €
55€ week
Tallinn
Tallinn